Insert the SD you prepared into the Raspberry Pi. Update SSID and PASSWORD with your Wi-Fi info.Īdd the files to the root folder of the SD card: The contents of the file should be as follows:Ĭtrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev This file also needs to be added to the root of the boot partition on the SD card. To support Wi-Fi, create a wpa_nf file that contains your Wi-Fi settings. In order to initially allow SSH access to the Raspberry Pi, an empty ssh file needs to be added to the root of the boot partition on the SD card. Win32 Disk Imager can be used to write the ISO image to an SD card on Windows.Įtcher can also be used which supports Mac, Linux, and Windows. The Raspbian image needs to be written to the SD card so the Raspberry Pi can boot off the image. iso file similar to the name -raspbian-jessie.img Step 2: Write ISO Image to SD Card The Lite version may work, but I have not tried it.Īt the time of this writing, I downloaded the April 2017 version. You can download Raspbian image from here. I referenced this blog post for initial information. This simplifies the overall setup as an extra keyboard and monitor is not needed. I opted for setting up the Raspberry Pi without using a keyboard or monitor attached to the Raspberry Pi. In the case of the Pi Zero, the male header will need to be soldered to the board. Setup the Raspberry Pi and the PiShield following the directions here. The following components are required for this setup. I primarily wanted to keep track of the steps I took to set this up. This works well when requiring outdoor motion sensors.įor indoors, I use the UAP-AC-PRO and UAP-AC-HD. I have had really good success using the Ubiquiti UniFi line of Wi-Fi access points. The Raspberry Pi Zero W supports Wi-Fi and will be able to transmit the sensor data wirelessly to QLab. Node-Red will be able to convert sensor data to OSC messages. The Raspberry Pi supports Node-Red, which is a programming tool for wiring together hardware devices, APIs and online services. I-CubeX recently released the PiShield for the Raspberry Pi that supports interfacing sensors to the Raspberry Pi. QLab supports trigger notifications via OSC (Open Sound Control) network commands. I wanted the ability to trigger QLab’s playback, from motion sensors, wirelessly. QLab is show control software for the Mac. This year, we are setting up Halloween scenes that are triggered by motion.Īs someone passes by the scene, the scene is triggered. Step 5: Determine the IP address of the Raspberry Pi.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |